|PRODUCT DATA||COLD PATCH|
|PP-1 BOND-X HIGH PERFORMANCE COLD PATCH|
Seaboard BOND-X High Performance Cold Patch is a high quality, pre-mixed, asphalt "cold patch" compound. Combining a carefully selected aggregate with a special bitumen formula.|
Seaboard BOND-X High Performance Cold Patch is the right choice for all types of pavement repair jobs.
Seaboard BOND-X High Performance Cold Patch repairs dangerous potholes, wide cracks, ruts, etc.; within minutes, regardless of the weather outside. Suitable for use on both concrete and asphalt pavement.
Seaboard BOND-X High Performance Cold Patch is highly recommended for spot repairs to driveways and dry pavement with no loss of bonding ability. The most important benefit to remember is the fact the Seaboard BOND-X High Performance Cold Patch is the "Permanent Patch" and should remain in the repaired area indefinitely. Money will be saved in labor costs because, workers will not be constantly repairing an area where a other types of "cold patch" asphalt mix was used.
Seaboard BOND-X High Performance Cold Patch is easy to apply with most repairs taking only a few minutes to complete. As an added feature, Seaboard BOND-X High Performance Cold Patch can be open to traffic immediately after it has been used.
|PREPARATION:||Simply sweep out the area to be repaired with a bristled brush or broom. It is a good idea to remove any loose debris, dirt, ice, or standing water from the area to be repaired. This action will promote good adhesion and bonding.|
|APPLICATION:||No heating or mixing is required. Simply shovel into the pothole, crack, or rut, straight from the container. If the fault is especially deep, i.e. over six inches, apply in two inch layers, compacting each layer in succession. Shovel enough material into the fault to slightly crown the "patch". When completed compress the "patch" with the pneumatic tamper. Area can be opened to traffic immediately.|
|COVERAGE:||Depth and width of pothole, crack, utility cut etc. will greatly influence the coverage rate achieved. As a rule however, a three gallon pail of Seaboard BOND-X High Performance Cold Patch will fill a two inch deep hole, four square feet is size.|
|DRYING TIME:||Immediate, following compacting of material.|
|CLEAN UP:||All tools should be cleaned immediately after use with a solvent base cleaner such as varsol, paint thinner or mineral spirits.|
|STORAGE:||Always keep container tightly closed when not in use to prevent "hardening" over long periods of storage.|
|PACKAGING:||Seaboard BOND-X High Performance Cold Patch is available in three gallon and five gallon pails.|
This information is to assist customers in determining if this product is suitable for the proposed application, and to satisfy themselves as to suitability of the contents. Nothing herein shall constitute a warranty, expressed or implied, including any warranty of merchantability or fitness, nor is protection from law or patent implied.
3601 FAIRFIELD ROAD
BALTIMORE, MARYLAND 21226
FACSIMILE (410) 355-5864